How to Trim Edge Cedar Paneling on Wall

How to Install Cedar Board on Interior Walls | Home Guides

1. Remove baseboard trim and other wall trim. Use a pry bar or the claw end of a hammer to slowly and carefully ease the trim away from the wall, saving the trim to re-use later if desired.

Get Price

Design Dilemma: How Do I Modernize My Cedar Walls?

While gray-toned wood walls are definitely a modern way to go, pairing cedar tone plank walls with gray flooring can work beautifully too. If the cedar is rough and/or rustic, go a bit more sleek on the floor with smooth, satin or matte finish slate or porcelain. The contrast between the wood and floor can be stunning.

Get Price

How to Install Paneling - The Seven Trust

The first step in how to install paneling is to remove all wall plates, outlets and any nails in the wall. Gently remove any crown moulding, baseboards and trim you plan on using again. Tip: For best results, set the paneling in the room for a few days before you install it. This will allow it to adjust to the humidity in a room.

Get Price

Install Bead Board Paneling And Trim - DIY in a hour

Installing the bead board panels. I begin this part of the installation by pre-cutting all the panels to the height I set for all walls, with a circular saw and straight edge. I also cut and installed the door trim, leaving about a quarter inch gap along the door jamb’s inner boundary, and leveled the lines I marked.

Get Price

Trimming Around Beadboard Paneling | Home Guides | SF Gate

If the beadboard ends at a wall about to wrap a corner, then the trim needs to end as well. Because a straight cut on the trim ends with an unfinished edge, give it a finished edge by making a return.

Get Price

How to SevenTrust Cedar Siding | DoItYourself.com

Some areas of the cedar siding, such as around openings or fixtures, may need caulking again. Check the entire wall thoroughly and make sure that any area which needs new caulk is tended to appropriately. Step 6 – Treat the Wood. The wood will need to be treated again. This will help further protect it from weather and UV light.

Get Price

DIY Wall Treatment: Faux Paneling | Better Homes & Gardens

To ensure tight joints where the vertical wood strips (stiles) and horizontal strips (rails) contact each other, the wall, and the existing trim, the wall needs to be flat. Check by using the edge of a level. Many walls bulge near corners or at the seams between drywall sheets.

Get Price

How to Install Tongue and Groove Paneling on Walls and Ceilings

Remove any old trim from your walls. As each section of tongue and groove wall paneling is installed, don’t worry about stud/rafters overrun. Secure sections with a nail on the tongue, and simply slide in the next cut when you need one. If it doesn’t line up to the stud/rafters, the end matching ensures that you won’t have any problems.

Get Price

Product Details

Product List